Having a pool in Texas is almost a necessity with the long hot summers. Your pool is one your largest investments and you want it to look great as you enjoy a swim on those hot summer days.
Over time calcium and grime will build up along the water line, over decorative rocks, waterfalls, and tile. JAC Mobile Blasting LLC has an eco-friendly process to remove the calcified residue without having to drain your pool.
Our scaling removal process will not scratch your tile, compromise the grout, or damage the stonework that makes your custom pool so special. Pumice stones, scrapers, wire brushes, even acid can etch your water line resulting in expensive repairs and even possible tile replacement.
Save time and your sanity by letting our team of professionals do the heavy lifting so you can enjoy your backyard oasis as it was meant to be relaxing with friends and family.
Mineral deposits can be formed from sprinklers and other water sources. We can clean deposits off fountains, tombstones, monuments, statutes, rock water faces, architectural rock and other outdoor areas where water has deposited minerals.
Call or email for a free estimate. Pools are custom built and therefore each job is different in nature. We typically charge by linear foot making our calcium removal a very affordable alternative vs. doing it by hand with expensive and unsafe chemicals.
Our team will arrive onsite to turn off the pool equipment so we can lower the water level approximately 10 to 12 inches leaving access to full water line.
We prep the area by covering plants, outdoor furniture, and any other items needed before we begin the calcium scale removal process.
The media we use is eco-friendly and safe for humans and pets. We use Kieserite which is blasted with compressed air ranging from 50-80 psi lifting the calcium deposit from the tile and the stone safely. Kieserite is just slightly courser than the scale builds up but not to course where it will scratch or etch ceramic and glass pool tile.
After the blasting process the deck and surrounding areas are swept up and blown clear of and media over spray. The area is then given a wash down removing any residual media that may embed in the porous areas.
Kieserite is water soluble and will dissipate over a short period of time. To help expedite the process we will vacuum large remaining deposits from the bottom of the pool.
At this point the cleaning is done, and we will ask that you fill your pool back to normal level. You will not want to run your equipment until the pool water is above the skimmers. Failure to do this can result in damage to your equipment. You will notice the water is cloudy and they will clear up as the water settles and the filter pumps have the ability to circulate the water. The process can vary from pool to pool based on efficiency of the filter and size of the pool.
Finally!!! Enjoy your backyard oasis. It may look a little cloudy, but it is perfectly safe to swim in the pool the same day we clean your pool. This will clear up in a couple of days after your system has been running. We recommend rinsing out your cartridge filter (the big filter) after a week or so.